|
|
 |
| Indentor |
 |
Height: 2.50mm Shape: Sharp Cone Point |
|
 |
| Hardness Tester Selection Chart |
 |
|
Our product line consists of various types of durometers applicable to specific materials
as indicated in the chart above.
Type A Durometer (ASKER A type), conforming to JIS K 6235 is the most popular type of durometer for measuring rubber hardness.
However, verification is recommended because a significant difference is estimated to be the largest when a durometer indicates measurement values from 10 to 90 points.
For hard specimens for which Type A Durometer readings indicate more than 90 points, measurements should be undertaken using the Type D Durometer (ASKER D type). However, for soft specimens with measurements of less than 20 points, the ASKER C type or Type E Durometer (ASKER E type) should be used. The most important consideration in using durometers is to select the correct type for purposes of measurement according to the specimen.
|
|
|
Specification |
|
|
|
| Standards |
|
JIS K 6253
JIS K 7215
ASTM D 2240
ISO 7619
ISO 868
DIN 53505 |
|
|
| Indication range |
|
0 point - 100 point (262 degree dial scale) |
|
|
| Minimum indication |
|
1 point (Accuracy : ±1 point) |
|
|
| Indentor Design (mm) |
|
Height: 2.50 30°Angle Sharp Cone Point Tip Radius 0.1 |
|
|
| Spring Forces [mN(g)] |
|
|
|
|
| Central hole of diameter of Pressure foot |
|
Φ3 |
|
|
Pressure foot
Dimension (mm) |
|
Φ12 Longer foot type Length: 18 |
|
|
| Outer Dimension (mm) |
|
Approx. Width 57×Depth 30×Height 94 |
|
|
| Weight (g) |
|
200 |
|
|
| Application |
|
hard rubber, plastic |
|
|
|
|
Outer Dimension (mm) |
|
|
 |
| A custom designed pressure foot durometer is available according to specimen conditions. |
|
|
Option |
|
|
 |
|
|
Two-pointer type (max-hand and active hand) of Rubber Hardness Tester
The stationary set hand (max-hand) makes the maximum value easier to read and allows the creep characteristics of a specimen.
Accurate measurement is made possible for specimens* for which stress relaxation occurs over time or for specimens for which it is difficult to take readings from the front.
*Materials for which the reading decreases immediately after the indentor has been pressed against the surface. |
|
|
 |
|
|
Constant Loader for Durometer
| · |
Constant loarder assures uniform test pressure eliminating false readings due to differences between operators in measuring by hand. |
| · |
High accuracy and repeatability of the hardness readings are assured by the flexible joint function. |
|
|
|
 |
|
|
Indentor Extension Tester
| · |
The gauge to check the indentor height on a durometer and the reading indicator mechanism. |
| · |
Inspection is conducted at 2, 50, and 100 points respectively. |
|
|
|
 |
|
|
Load Tester for Hardness Tester
| · |
Tester to check load properties of the spring on a durometer |
| · |
Inspection is conducted at 2, 50, and 75 points respectively. |
|
|
|
ASKER_Durometer__4f523e297ab12.jpg